Changing the engine oil on your BMW G 310 GS is the single most important maintenance job you can do yourself. Fresh oil keeps the engine cool, reduces wear on internal parts, and keeps shifts smooth. Most riders can finish this job in under 45 minutes with basic hand tools.
Your BMW G 310 GS calls for 5W-40 (API SJ / JASO MA2) oil, with a capacity of about 1.65 liters when the filter is changed. The factory service interval is every 6000 miles — sooner if you ride hard, sit in traffic a lot, or do frequent short trips.
BMW G 310 GS quick service specs
| Item | Specification |
|---|---|
| Engine oil | 5W-40 (API SJ / JASO MA2) |
| Oil capacity | 1.65 liters |
| Oil change interval | 6000 miles |
| Chain slack | 40-50 mm |
| Spark plug | NGK LMAR9D-J |
| Tire pressure (F/R) | 25 PSI front / 28 PSI rear |
| Battery | 12V 8Ah AGM |
How to change the engine oil, step by step
- Warm the engine for 2-3 minutes so the oil flows out easily, then shut it off and place the bike upright on a paddock stand or center stand.
- Remove the oil filler cap and place a drain pan under the engine. Remove the drain bolt and let the oil drain completely (5-10 minutes).
- Remove the old oil filter. Lightly coat the new filter’s rubber seal with fresh 5W-40 (API SJ / JASO MA2) oil and install it hand-tight plus a quarter turn.
- Reinstall the drain bolt with a new crush washer and torque to the factory spec in your owner’s manual.
- Pour in 1.65 liters of 5W-40 (API SJ / JASO MA2) oil through the filler. Check the sight glass or dipstick with the bike upright — level should sit between the marks.
- Start the engine, let it idle for a minute, check for leaks around the drain bolt and filter, then re-check the oil level and top up if needed.
- Log the mileage and date. Reset any service reminder if your BMW G 310 GS has one.
Common mistakes to avoid
- Over-tightening the drain bolt — this strips the oil pan threads, an expensive fix.
- Forgetting the crush washer — a reused washer is the most common cause of slow oil weeps.
- Using the wrong viscosity — stick with 5W-40 (API SJ / JASO MA2) unless your manual lists an approved alternative for your climate.
- Overfilling — too much oil causes foaming and can blow seals. Check the level with the bike upright, not on the side stand.
FAQ
How often should I change the oil on my BMW G 310 GS?
Every 6000 miles under normal use. If you ride in dust, heat, or stop-and-go traffic, change it a little earlier — oil is cheap, engines are not.
Can I use synthetic oil in the BMW G 310 GS?
Yes, as long as it meets the 5W-40 (API SJ / JASO MA2) viscosity and the JASO MA/MA2 spec your manual requires. Avoid energy-conserving car oils — they can make the clutch slip.
How do I dispose of used oil?
Pour it into a sealed container and take it to an auto parts store or municipal recycling point. Never pour it on the ground or down a drain.
Related guides
Dan Heiman
Writer at Helmet Today, covering helmet reviews, fit and riding safety.
